# PM bands Splits the size distribution into size-selective fractions — PM₁₀, PM₂.₅, PM₀.₅ and the bands between them — and stacks them over time. This is the view that maps onto how exposure limits are usually written. ```{figure} ../_static/gui/tab-pm-bands.png :alt: The PM bands tab showing three stacked size fractions over time with their means in the legend :width: 100% Three stacked bands with their mean concentrations in the legend. The band heights add up to the total below the largest cut-off. ``` **Available for:** size-resolved (2D) datasets only. ## Cut-offs A comma-separated list of cut diameters in **micrometres** — `0.5, 2.5, 10` by default. Each cut-off defines a size-selective fraction: PM₂.₅ is everything below 2.5 µm. You can use any cut-offs the instrument's size range supports. Asking for a cut-off beyond the largest bin simply gives you everything the instrument measured. ## Basis The quantity the fractions are computed on: mass (`dM`, the default and the usual choice for PM), number (`dN`), surface area (`dS`) or volume (`dV`). PM limits are written in mass, so `dM` is normally what you want — and it depends on the particle density set on the [Metadata](metadata.md) tab. Number-based bands are useful for a different question: whether an event was many small particles or a few large ones. ## Cumulative Changes what each band means: - **Off** (default) — each band is the fraction **between** successive cut-offs: `0–PM0.5`, `PM0.5–PM2.5`, `PM2.5–PM10`. The bands are independent and stack to the total. - **On** — each band is **everything below** its cut-off: PM₀.₅, PM₂.₅, PM₁₀. The bands overlap, each containing the ones below it. Use the independent bands to see which size range an event lives in; use cumulative when you want the PM values as an exposure limit defines them. ## Activity Restricts the plot to one marked activity. Leave it on **All data** for the whole record. The legend reports each band's mean over whatever is shown, so switching activity gives you the per-task means directly. ## Under the hood ```python import aerosoltools as at data = at.load_ops_file("measurement.csv") data.plot_PM_timeseries( PM_values=[0.5, 2.5, 10], # Cut-offs (µm) dtype="dM", # Basis cumulative=False, # Cumulative activity="All data", # Activity ) ``` See [5 — Plotting](../examples/05-plotting.ipynb) and [4 — Statistics and exposure](../examples/04-statistics-and-exposure.ipynb).